Search results
Results from the WOW.Com Content Network
Interior of a Boeing/Stearman PT-17 showing small channel section stringers. In engineering, a longeron or stringer is a load-bearing component of a framework. The term is commonly used in connection with aircraft fuselages and automobile chassis. Longerons are used in conjunction with stringers to form structural frameworks. [1]
This was the exact position that the pilot's head would be in during an actual landing. In the exercise, the STA was still flying 20 feet (6 m) above the ground. The instructor pilot deselected the simulation mode, stowed the thrust reversers, and the instructor executed a go-around, never actually landing the aircraft (on training approaches).
In 1976, NASA selected Northrup Strip as the site for shuttle pilot training. A second runway was added crossing the original north-south landing strip, and in 1979 both lakebed runways were lengthened to 35,000 ft (10,668 m), which includes 15,000 ft (4,572 m) usable runway with 10,000 ft (3048 m) extensions on either end, to allow White Sands Space Harbor to serve as shuttle backup landing ...
With the landing of Discovery after the STS-131 mission, Leonardo was transferred back to the Space Station Processing Facility at Kennedy Space Center. Leonardo began receiving modifications and reconfigurations immediately to convert it for permanent attachment to the space station and to facilitate on-orbit maintenance. [ 12 ]
The Fulton system in use The Fulton system in use from below. The Fulton surface-to-air recovery system (STARS), also known as Skyhook, is a system used by the Central Intelligence Agency (CIA), United States Air Force, and United States Navy for retrieving individuals on the ground using aircraft such as the MC-130E Combat Talon I and B-17 Flying Fortress.
The Shuttle Landing Facility (SLF), also known as Launch and Landing Facility (LLF) [1] (IATA: QQS, ICAO: KTTS, FAA LID: TTS), is an airport located on Merritt Island in Brevard County, Florida, United States. It is a part of the Kennedy Space Center and was used by Space Shuttle for landing until July 2011.
A corkscrew landing involves positioning the aircraft over the landing site at altitude, then descending in a steeply banked spiral path. [1] [2] To do this the pilot of the aircraft banks the aircraft from the horizontal and begins a fast descent. Once closer to the airfield, the pilot will slowly level off and begin descent into the runway. [3]
The primary Space Shuttle landing site was the Shuttle Landing Facility at KSC, where 78 of the 133 successful landings occurred. In the event of unfavorable landing conditions, the Shuttle could delay its landing or land at an alternate location. The primary alternate was Edwards AFB, which was used for 54 landings. [24]: