Search results
Results from the WOW.Com Content Network
Ignition system of a flat-twin Citroën 2CV. A wasted spark system is a type of ignition system used in some four-stroke cycle internal combustion engines.In a wasted spark system, the spark plugs fire in pairs, with one plug in a cylinder on its compression stroke and the other plug in a cylinder on its exhaust stroke.
Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...
coil, distributor, high voltage 4a, 4b distributor with two separate circuits, high voltage 7 terminal on ballast resistor, to distributor 15 battery+ from ignition switch 16 15a from ballast resistor to coil and starter motor 16 15e battery+ from ignition switch, also when starter motor runs Preheat (Diesel engines) 15 preheat in + 17 start 19
The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...
An ignition coil is used in the ignition system of a spark-ignition engine to transform the battery voltage to the much higher voltages required to operate the spark plug(s). The spark plugs then use this burst of high-voltage electricity to ignite the air-fuel mixture. The ignition coil is constructed of two sets of coils wound around an iron ...
This system worked like all Kettering (points/coil) ignition systems: the opening points trigger the collapse of the magnetic field in the ignition coil, producing a high voltage pulse which flows through the spark plug wire to the spark plug. Some electronic ignition systems exist that are not CDI.
In spark-ignition internal combustion engines, knocking (also knock, detonation, spark knock, pinging or pinking) occurs when combustion of some of the air/fuel mixture in the cylinder does not result from propagation of the flame front ignited by the spark plug, but when one or more pockets of air/fuel mixture explode outside the envelope of the normal combustion front.
The higher fully-charged voltages of lead-acid (2.0) and Li-ion (4.2) cells, if applied directly to a regular 1.5 volt glow plug, will cause it to burn out instantaneously, so either a resistor of the proper value and wattage, or a high-power germanium transistor's base/emitter junction (in a series connection with one of the plug's terminals ...