Search results
Results from the WOW.Com Content Network
The OHCI driver provides low- and full-speed functions for USB ports of all other motherboard chipset vendors' integrated USB host controllers or discrete host controllers attached to the computer's expansion bus. The EHCI driver provided high-speed functions for USB ports on the motherboard or on the discrete USB controller.
The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.
The signaling rate of the USB device is determined during the reset signaling. After reset, the USB device's information is read by the host and the device is assigned a unique 7-bit address. If the device is supported by the host, the device drivers needed for communicating with the device are loaded and the device is set to a configured state ...
Host Controller Interface (FireWire), an interface that enables a FireWire host controller to communicate with a driver; Host Controller Interface (USB), an interface that enables a USB host controller to communicate with a driver; Host Controller Interface (Bluetooth) in Bluetooth protocols
WinUSB is a generic USB driver provided by Microsoft, for their operating systems starting with Windows Vista but which is also available for Windows XP. It is aimed at simple devices that are accessed by only one application at a time (for example instruments like weather stations, devices that only need a diagnostic connection or for firmware upgrades).
The Kernel-Mode Driver Framework (KMDF) model continues to allow development of kernel-mode device drivers but attempts to provide standard implementations of functions that are known to cause problems, including cancellation of I/O operations, power management, and plug-and-play device support.
Retrieval of the descriptors would especially allow for determining the USB Class, VID, and PID, which are often used for determining the correct USB driver for the device. A USB device can be located by the bus:device address, or by the hub:port address. [16] Also, after the descriptors is retrieved, the host performs another control transfer ...
During that time no generic USB mass-storage driver was produced by Microsoft (including for Windows 98), and a device-specific driver was needed for each type of USB storage device. Third-party, freeware drivers became available for Windows 98 and Windows 98SE, and third-party drivers are also available for Windows NT 4.0.