Ads
related to: grip length bolt
Search results
Results from the WOW.Com Content Network
Bolt with a nut. A bolt is an ... For this reason, many bolts have a plain unthreaded shank (called the grip length), as this makes for a better, stronger dowel.
Similar to a wood screw, except that it is generally much larger running to lengths up to 15 in (381 mm) with diameters from 0.25–0.5 in (6.35–12.70 mm) in commonly available (hardware store) sizes (not counting larger mining and civil engineering lags and lag bolts) and it generally has a hexagonal drive head.
Thread engagement is the length or number of threads that are engaged between the screw and the female threads. Bolted joints are designed so that the bolt shank fails in tension before the threads fail in shear, but for this to hold true, a minimum thread engagement must be achieved. The following equation defines this minimum thread ...
For this reason, bolted joints should always be designed with careful consideration for the grip length. If a short grip length can not be avoided, the use of conical spring washers ( Belleville washers or disc springs) can also reduce the loss of bolt pre-load due to embedment.
Barrel length the barrel length is measured from underneath the head to the end of the barrel. Normally the length of the barrel is shorter than the thickness of the material being clamped. Another common term is "grip length", which is the thickness of the material that a mating bolt can effectively fasten or clamp. Thread size
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
Another common inspection point is the straightness of a bolt or screw. This topic comes up often when there are assembly issues with predrilled holes as the first troubleshooting point is to determine if the fastener or the hole is at fault. ASME B18.2.9 "Straightness Gage and Gaging for Bolts and Screws" was developed to address this issue.
The anatomy of a gunstock on a Ruger 10/22 semi-automatic rifle with Fajen thumbhole silhouette stock. 1) butt, 2) forend, 3) comb, 4) heel, 5) toe, 6) grip, 7) thumbhole A gunstock or often simply stock, the back portion of which is also known as a shoulder stock, a buttstock, or simply a butt, is a part of a long gun that provides structural support, to which the barrel, action, and firing ...
Ads
related to: grip length bolt