enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   A nutdriver or nut driver is a hand tool for tightening or loosening nuts and bolts. It essentially consists of a socket attached to a shaft and cylindrical handle and is similar in appearance and use to a screwdriver. [1] They generally have a hollow shaft to accommodate a shank onto which a nut is threaded.

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Slot screw drives have a single horizontal indentation (the slot) in the fastener head and is driven by a "common blade" or flat-bladed screwdriver.This form was the first type of screw drive to be developed, and, for centuries, it was the simplest and cheapest to make because it can just be sawed or filed.

4. List of components of oil drilling rigs - Wikipedia

   en.wikipedia.org/wiki/List_of_components_of_oil...

   Drill bit (#26) is a device attached to the end of the drill string that breaks apart the rock being drilled. It contains jets through which the drilling fluid exits. Drill floor (#21) is the area on the rig where the tools are located to make the connections of the drill pipe, bottom hole assembly, tools and bit. It is considered the main area ...

5. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   Special combination drill-driver bits and adapters let an operator rapidly alternate between the two. Variations include impact drivers, which provide two types of 'hammering' force for improved performance in certain situations, and "right-angle" drivers for use in tight spaces. Many options and enhancements, such as built-in bubble levels ...

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

8. MDEQ settles with UK-based Drax Group for air violations at ...

   www.aol.com/mdeq-settles-uk-based-drax-091709075...

   The U.K.-based Drax Group settled with MDEQ for $225,000 for alleged air pollution violations. Skip to main content. 24/7 Help. For premium support please call: 800-290-4726 more ways to reach us ...

9. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   Attaching the barrel to the receiver using a barrel nut and a barrel with a shoulder is an alternative to action threads, which has been used in firearms such as the Sten gun and AR-15. Hand tools Quick barrel change systems is an increasingly popular alternative, as seen in for example SIG Sauer 200 STR , Roessler Titan or Blaser R8 .