Search results
Results from the WOW.Com Content Network
The thin red circular contour line in the middle of the map indicates the top of the oil reservoir. Because gas floats above oil, the thin red contour line marks the gas/oil contact zone. Directional drilling would be used to target the gas and oil reservoir. Directional drilling (or slant drilling) is the practice of drilling non-vertical bores.
Directional boring, also referred to as horizontal directional drilling (HDD), is a minimal impact trenchless method of installing underground utilities such as pipe, conduit, or cables in a relatively shallow arc or radius along a prescribed underground path using a surface-launched drilling rig. Directional boring offers significant ...
The ability to vary the directional tendency of the assembly comes from varying the weight on the bit. A fixed assembly has only one directional tendency. The weight on bit allows you to tune that tendency. The bottom-hole assembly (BHA) can be: slick with no stabilisers; a pendulum bottom-hole assembly for reducing the deviation of a well
A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.
If the soil is rocky the tool may be deflected or fail to pound forward due to its inability to break the rock. These drawbacks can be overcome by directional boring or straight-line horizontal underground boring machines that use either wet (slick boring, slurry boring) or dry (auger boring, jack and bore) methods.
For small diameters, length-to-diameter ratios of up to l/D ≤ 100 can be achieved, in special cases even up to l/D = 900. [ 2 ] [ 3 ] [ 4 ] With large diameters, the l/D ratio is usually limited by the travel or the bed length of the deep hole drilling machine.
Engine displacement is calculated based on bore, stroke length and the number of cylinders: [1] displacement = π ( 1 / 2 × bore ) 2 × stroke × n cylinders. The stroke ratio, determined by dividing the bore by the stroke, traditionally indicated whether an engine was designed for power at high engine speeds or torque at lower engine ...
They are suitable for use in ground with a strength of up to about 10 MPa (1,500 psi) with low water inflows. They can bore tunnels with cross-section in excess of 10 m (30 ft). A backactor arm or cutter head bore to within 150 mm (6 in) of the edge of the shield. After a boring cycle, the shield is jacked forward to begin a new cycle.