enow.com Web Search

  1. Ads

    related to: 30mm cantilever low mount adapter connector for led lights to tv wire cable

Search results

  1. Results from the WOW.Com Content Network
  2. Lightning (connector) - Wikipedia

    en.wikipedia.org/wiki/Lightning_(connector)

    Apple Lightning to USB-A cable. Lightning is an 8-pin digital connector. Unlike the 30-pin dock connector it replaced (and USB Type-A and -B connectors), it is reversible. [23] Most Lightning devices only support USB 2.0, which has a maximum transfer speed of 480 Mbit/s or 60 MB/s. With USB 2.0, only one lane is in use at a time.

  3. Coaxial power connector - Wikipedia

    en.wikipedia.org/wiki/Coaxial_power_connector

    A coaxial power connector is an electrical power connector used for attaching extra-low voltage devices such as consumer electronics to external electricity. Also known as barrel connectors , concentric barrel connectors or tip connectors , these small cylindrical connectors come in an enormous variety of sizes.

  4. GU24 lamp fitting - Wikipedia

    en.wikipedia.org/wiki/GU24_lamp_fitting

    Compact fluorescent lamp with GU24 cap. A GU24 lamp fitting is a bi-pin connector for compact fluorescent lamps (CFL) or LED lamps that uses a bayonet mount–like twist-lock bi-pin connector instead of the Edison screw fitting used on many CFLs, LED lamps and incandescent light bulbs.

  5. RF connector - Wikipedia

    en.wikipedia.org/wiki/RF_connector

    An RF connector must not allow external signals into the circuit through electromagnetic interference and capacitive pickup. Mechanically, RF connectors may provide a fastening mechanism ( thread , bayonet , braces, blind mate ) and springs for a low ohmic electric contact while sparing the gold surface, thus allowing very high mating cycles ...

  6. Snap-fit - Wikipedia

    en.wikipedia.org/wiki/Snap-fit

    The cantilever snap-fit is the most commonly used snap-fit of the three. [6] [7] A cantilever design can be multiple use or permanent. A multiple-use snap-fit usually has a lever or pin to be pushed, in order to undo the snap-fit. However, on a permanent snap-fit there is no lever or pin.

  7. BNC connector - Wikipedia

    en.wikipedia.org/wiki/BNC_connector

    Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [9] using a special power or manual tool. [10] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used ...

  8. IEC 60320 - Wikipedia

    en.wikipedia.org/wiki/IEC_60320

    A variety of different kinds of IEC 60320 plugs and sockets. IEC 60320 Appliance couplers for household and similar general purposes [1] is a set of standards from the International Electrotechnical Commission (IEC) specifying non-locking connectors for connecting power supply cords to electrical appliances of voltage not exceeding 250 V (a.c.) and rated current not exceeding 16 A. [1 ...

  9. Adapter - Wikipedia

    en.wikipedia.org/wiki/Adapter

    A passive electric power adapter, sometimes called a travel plug or travel adapter, allows using a plug from one region with a foreign socket. As other countries supply 120-volt, 60 Hz AC, using a travel adapter in a country with a different supply poses a safety hazard if the connected device does not support both input voltages.

  1. Ads

    related to: 30mm cantilever low mount adapter connector for led lights to tv wire cable