Search results
Results from the WOW.Com Content Network
European Standard (EN 13402-1) pictogram example for a men's jacket, with chest as primary measurement, and height and waist as secondary measurements. The first part [ 2 ] of the standard defines the list of body dimensions to be used for designating clothing sizes, together with an anatomical explanations and measurement guidelines.
GB/T 1335.1-2008 Size designation of clothes - Men; GB/T 1335.2-2008 Size designation of clothes - Women; GB/T 1335.3-2008 Size designation of clothes - Children; GB/T 2668-2002 Sizes for coats, jackets and trousers; GB/T 14304-2002 Sizes for woolen garments
I-beams are still available in US sizes from many Canadian manufacturers. In Mexico , steel I-beams are called IR and commonly specified using the depth and weight of the beam in metric terms. For example, a "IR250x33" beam is approximately 250 mm (9.8 in) in depth (height of the I-beam from the outer face of one flange to the outer face of the ...
The typical range lies between 1 ⁄ 2 to 2 ⁄ 3 inch (12.7 to 16.9 mm) for the UK/US size system and 4 ⁄ 3 to 5 ⁄ 3 cm (13.3 to 16.7 mm) for the European size system, but may extend to 1 ⁄ 4 to 3 ⁄ 4 inch (6.4 to 19.1 mm) and 2 ⁄ 3 to 6 ⁄ 3 cm (6.7 to 20.0 mm).
U.S. standard clothing sizes for women were originally developed from statistical data in the 1940s and 1950s. At that time, they were similar in concept to the EN 13402 European clothing size standard, although individual manufacturers have always deviated from them, sometimes significantly.
The proportion of UK export to the European Union has been noted to be in decline, since exports to non-EU countries have increased at a faster rate. [25] On the European side, according to Eurostat, exports from the EU 27 to the UK have increased from 316 euro billions in 2015 to 319 euro billions in 2019. In the same time, according to ...
IET Wiring Regulations", informally called in the UK electrical community "The Regs", is the national standard in the United Kingdom for electrical installation and the safety of electrical wiring systems. [1] It did not become a recognized British Standard until after the publication of the 16th edition in 1992.
(In Europe, taper female pipe threads are not commonly used.) Longscrew threads These are parallel pipe threads used where a pressure-tight joint is achieved by the compression of a soft material (such as an o-ring seal or a washer) between the end face of the male thread and a socket or nipple face, with the tightening of a backnut.