Search results
Results from the WOW.Com Content Network
dhcpd (an abbreviation for "DHCP daemon") was a DHCP server program that operates as a daemon on a server to provide Dynamic Host Configuration Protocol (DHCP) service to a network. [3] This implementation, also known as ISC DHCP, is one of the first and best known, but there are now a number of other DHCP server software implementations available.
The DHCP server permanently assigns an IP address to a requesting client from a range defined by an administrator. This is like dynamic allocation, but the DHCP server keeps a table of past IP address assignments, so that it can preferentially assign to a client the same IP address that the client previously had. Manual allocation
In this overview of operating system support for the discussed DHCP server, the following terms indicate the level of support: No indicates that it does not exist or was never released. Yes indicates that it has been officially released in a fully functional, stable version.
Kea is an open-source DHCP server developed by the Internet Systems Consortium, authors of ISC DHCP, also known as DHCPd.Kea and ISC DHCP are both implementations of the Dynamic Host Configuration Protocol, a set of standards established by the Internet Engineering Task Force (IETF).
ipconfig in Mac OS X serves as a wrapper to the IPConfiguration agent, and can be used to control the Bootstrap Protocol and DHCP client from the command-line interface. [8] For example, you can release and renew an IP address if it happened to be assigned incorrectly by the DHCP server during the automated assignment process. [9]
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
This is a list of POSIX (Portable Operating System Interface) commands as specified by IEEE Std 1003.1-2024, which is part of the Single UNIX Specification (SUS). These commands can be found on Unix operating systems and most Unix-like operating systems.
Below is a list of FTP commands that may be sent to a File Transfer Protocol (FTP) server. It includes all commands that are standardized by the Internet Engineering Task Force (IETF) in RFC 959, plus extensions. Note that most command-line FTP clients present their own non-standard set of commands to