Search results
Results from the WOW.Com Content Network
The first known lawn mower had a cylinder cutting gear made of iron. [citation needed] It was used to mow sporting grounds and wide-ranging gardens.As manufacturers changed the design and structure of mowers, the cutting mechanism also developed and evolved into several varieties, including cylinder/reel blades, deck blades, mulching blades, and lifting blades.
Two archetypes of this type of mower are the Bush Hog which is made by Bush Hog, Inc. [1] of Selma, Alabama, and the Flex-Wing by RhinoAg of Gibson City, Illinois.The formal name for this type of implement is a rotary cutter or rotary mower, although it differs from mowers in that it does not cut with a sharp blade, but rather severs with an intentionally very dull wedge-like blade.
The tip-speed ratio, λ, or TSR for wind turbines is the ratio between the tangential speed of the tip of a blade and the actual speed of the wind, v. The tip-speed ratio is related to efficiency, with the optimum varying with blade design. [1] Higher tip speeds result in higher noise levels and require stronger blades due to larger centrifugal ...
From 1977 onward, the 351W shared the same head casting as the 302, differing only in bolt hole diameters (7/16 inch for the 302, 1/2 inch for the 351W). Early blocks (casting ID C9OE-6015-B) had enough metal on bearing saddles 2, 3, and 4 for four-bolt mains, and as with all small-block Fords (SBFs), were superior in strength to most late ...
Scalpel blades are usually made of hardened and tempered steel, stainless steel, or high carbon steel; in addition, titanium, ceramic, diamond and even obsidian knives are not uncommon. For example, when performing surgery under MRI guidance, steel blades are unusable (the blades would be drawn to the magnets and would also cause image artifacts).
Gun No. 213 had a liner. The gun was described as a 5-inch (127 mm) gun but with a 4-inch bore in the 1902 handbook, this indicated its higher power and also the fact the barrel was actually more the size of a 5-inch/40 caliber gun than a 4-inch gun. The ammunition was about 7 lb (3.2 kg) heavier than a 4-inch/40 caliber round.
On the upper deck was the flight deck, cargo hold, crew quarters, a toilet and baggage compartments. On the roof of the flight deck were two pitot tubes and a retractable spotlight. The large flight deck was 21 feet 4 inches (6.50 m) long and 9 feet 6 inches (2.90 m) wide with full headroom throughout. At the front was the cockpit.
Retreating blade stall is a hazardous flight condition in helicopters and other rotary wing aircraft, where the retreating rotor blade has a lower relative blade speed, combined with an increased angle of attack, causing a stall and loss of lift. Retreating blade stall is the primary limiting factor of a helicopter's never exceed speed, V NE. [1]