Search results
Results from the WOW.Com Content Network
Centrifugal governors are used in many modern repeating watches to limit the speed of the striking train, so the repeater does not run too quickly. Another kind of centrifugal governor consists of a pair of masses on a spindle inside a cylinder, the masses or the cylinder being coated with pads, somewhat like a centrifugal clutch or a drum brake.
A governor, or speed limiter or controller, is a device used to measure and regulate the speed of a machine, such as an engine.. A classic example is the centrifugal governor, also known as the Watt or fly-ball governor on a reciprocating steam engine, which uses the effect of inertial force on rotating weights driven by the machine output shaft to regulate its speed by altering the input flow ...
This fictitious force is often applied to rotating devices, such as centrifuges, centrifugal pumps, centrifugal governors, and centrifugal clutches, and in centrifugal railways, planetary orbits and banked curves, when they are analyzed in a non–inertial reference frame such as a rotating coordinate system.
This page was last edited on 15 September 2015, at 13:47 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Older models such as the Honda C50 used a simple centrifugal governor as part of the transmission, which progressively and severely advanced the ignition as speed rose past a set point, causing engine power to fall off rapidly at higher rpm and road speed, but maintaining the low- and moderate-speed hill climbing ability of the unrestricted ...
This is achieved by use of a constant-speed unit (CSU) or propeller governor, which automatically changes the propeller's blade pitch. Most engines produce their maximum power in a narrow speed band. The CSU allows the engine to operate in its most economical range of rotational speeds , regardless of whether the aircraft is taking off or cruising.
A governor was used by James Watt and Matthew Boulton in 1788 to control steam engines, but the use of governors dates at least back to the 17th century. On an engine, the governor uses centrifugal force to adjust the throttle position to adapt the engine's speed to different loads (e.g., when going up a hill).
By using a simple centrifugal governor, the speed of the motor may be controlled. When the governor detects an over-speed it interrupts the cam linkage so that the switches are activated for less time and so the motor slows. [6] As there is already a cam and switch mechanism required, the addition of a governor link is a relatively simple addition.