Search results
Results from the WOW.Com Content Network
In Linux, the parameter is called net.ipv4.ip_forward. In most systems, the command sysctl -w parameter=1 will enable a certain behavior. This will persist until the next reboot. If the behavior should be enabled whenever the system boots, the line parameter=1 can be added/rewritten to the file /etc/sysctl.conf. Additionally, some sysctl ...
Forward compatibility or upward compatibility is a design characteristic that allows a system to accept input intended for a later version of itself. The concept can be applied to entire systems, electrical interfaces , telecommunication signals , data communication protocols , file formats , and programming languages .
In the DS field, a range of eight values (class selectors) is used for backward compatibility with the former IPv4 IP precedence field. Today, DiffServ has largely supplanted TOS and other layer-3 QoS mechanisms, such as integrated services (IntServ), as the primary architecture routers use to provide QoS.
The type of service (ToS) field is the second byte of the IPv4 header. It has had various purposes over the years, and has been defined in different ways by five RFCs. [1] Prior to the redefinition, the ToS field could specify a datagram's priority and request a route for low-latency, high-throughput, or highly-reliable service.
Explicit Congestion Notification (ECN) is an extension to the Internet Protocol and to the Transmission Control Protocol and is defined in RFC 3168 (2001). ECN allows end-to-end notification of network congestion without dropping packets.
Field Size (bits) Description Copied: 1: Set to 1 if the options need to be copied into all fragments of a fragmented packet. Option Class: 2: A general options category. 0 is for control options, and 2 is for debugging and measurement. 1 and 3 are reserved.
Port Control Protocol (PCP) is a computer networking protocol that allows hosts on IPv4 or IPv6 networks to control how the incoming IPv4 or IPv6 packets are translated and forwarded by an upstream router that performs network address translation (NAT) or packet filtering.
An ARP probe in IPv4 is an ARP request constructed with the SHA of the probing host, an SPA of all 0s, a THA of all 0s, and a TPA set to the IPv4 address being probed for. If some host on the network regards the IPv4 address (in the TPA) as its own, it will reply to the probe (via the SHA of the probing host) thus informing the probing host of ...