Search results
Results from the WOW.Com Content Network
Dynamic height is a way of specifying the vertical position of a point above a vertical datum; it is an alternative for orthometric height or normal height. It can be computed by dividing the location's geopotential number by the normal gravity at 45 degree latitude and zero height, a constant value (9.806199203 m/s 2 ). [ 1 ]
The orthometric height (symbol H) is the vertical distance along the plumb line from a point of interest to a reference surface known as the geoid, the vertical datum that approximates mean sea level. [1] [2] Orthometric height is one of the scientific formalizations of a layman's "height above sea level", along with other types of heights in ...
Topographer's rods are special purpose rods used in topographical surveys. The rod has the zero mark at mid-height and the graduations increase in both directions away from the mid-height. In use, the rod is adjusted so that the zero point is level with the instrument (or the surveyor's eye if he is using a hand level for low-resolution work).
Height above mean sea level is a measure of a location's vertical distance (height, elevation or altitude) in reference to a vertical datum based on a historic mean sea level. In geodesy, it is formalized as orthometric height. The zero level varies in different countries due to different reference points and historic measurement periods.
A heightmap contains one channel interpreted as a distance of displacement or "height" from the "floor" of a surface and sometimes visualized as luma of a grayscale image, with black representing minimum height and white representing maximum height. When the map is rendered, the designer can specify the amount of displacement for each unit of ...
The unit was used, especially by IBM managers, [97] to express the amount of work required to develop a piece of software. Given that estimates of 20 lines of functional code per day per programmer were often used, it is apparent that 1 K-LOC could take one programmer as long as 50 working days, or 10 working weeks.
An alternative proposed by Brokaw and Thompson (2000) is D x, whereby the x indicates the exact height above the floor (and along the stem) at which the diameter is measured, e.g. D 130 denotes a diameter measured at 130 cm above the ground and along the stem [6].
If the model was constructed based on a set of data, one must determine for which systems or situations the known data is a "typical" set of data. The question of whether the model describes well the properties of the system between data points is called interpolation , and the same question for events or data points outside the observed data ...