Ads
related to: weep hole covers for brick wallsebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Components on a concrete masonry unit and brick cavity wall. A cavity wall is composed of two masonry walls separated by an air space. The outer wall is made of brick and faces the outside of the building structure. [6] The inner wall may be constructed of masonry units such as concrete block, structural clay, brick or reinforced concrete. [6]
Weep hole. A weep, a weep hole, or a weep-brick is a small opening that allows water to drain from within an assembly. Weeps are located at the bottom of the object to allow for drainage; the weep hole must be sized adequately to overcome surface tension.
Through wall flashing Spans the thickness of the wall and directs water to weep holes. Cap flashing (drip cap) Often used above windows and doors. Drip edge A metal used at the edges of a roof. Step flashing (soaker, base flashing) Pieces of flashing material which overlap each other in "steps". Counter flashing (cap flashing) Covers a base ...
Because the masonry veneer is non-structural, it must be tied back to the building structure to prevent movement under wind and earthquake loads. Brick ties are used for this purpose, and may take the form of corrugated metal straps nailed or screwed to the structural framing, or as wire extensions to horizontal joint reinforcement in a fully masonry veneer or cavity wall.
If the wall is a thick one, the holes should extend quite through it. The fire boxes with air-blast, already described, are then set to work on both sides of the wall, at the level of the bore-holes, until the brickwork is thoroughly heated and dried. In the Charlottenburg Palace this result has been attained with walls 1 metre (39 inches) thick.
In this context, the brick masonry is primarily decorative, not structural. The brick veneer is generally connected to the structural wall by brick ties (metal strips that are attached to the structural wall, as well as the mortar joints of the brick veneer). There is typically an air gap between the brick veneer and the structural wall.
The wood pieces labeled "beveled nailing strips" act as screed rails in this installation of a screed coating on Hy-Rib brand wire lath.. A weep screed or sill screed is a screed rail which has drainage holes to allow moisture which penetrated an exterior plaster or stucco coating to drain through the screed.
Core-and-veneer, brick and rubble, wall and rubble, ashlar and rubble, and emplekton all refer to a building technique where two parallel walls are constructed and the core between them is filled with rubble or other infill, creating one thick wall. [1] Originally, and in later poorly constructed walls, the rubble was not consolidated.
Ads
related to: weep hole covers for brick wallsebay.com has been visited by 1M+ users in the past month