Ad
related to: difference between suspension and spacer lift gate operator
Search results
Results from the WOW.Com Content Network
A hydraulic cantilever tail lift on the back of a truck Four stages of deployment on an ambulance tail lift Control for a tail lift. A tail lift (term used in the UK, also called a "liftgate" in North America) is a mechanical device permanently installed on the rear of a work truck, van, or lorry, and is designed to facilitate the handling of goods from ground level or a loading dock to the ...
A 2001 GMC Sierra Stepside with a 6" suspension lift. A suspension lift is a modification to a vehicle to raise the ride height. It is done for the purpose of improving the off road performance of SUVs or trucks and other off-road vehicles, or for cosmetic purposes. Suspension lifts can enable steeper approach, departure, and breakover angles ...
An active suspension is a type of automotive suspension that uses an onboard control system to control the vertical movement of the vehicle's wheels and axles relative to the chassis or vehicle frame, rather than the conventional passive suspension that relies solely on large springs to maintain static support and dampen the vertical wheel movements caused by the road surface.
The bottom of the legs are set in two holes on the ground, spreading them apart. There is a rope to tie the two legs together near the bottom to prevent them from spreading apart further. On the top side, the two legs are connected together by a lashing but with a small spacer block placed between the legs. A sling, which may be made from ropes ...
The main difference between them is the different structure. The frame dump trailer has a large beam that runs along the bottom of the trailer to support it. The frameless dump trailer has no frame under the trailer but has ribs that go around the body for support and the top rail of the trailer serves as a suspension bridge for support.
A MacPherson strut combines the primary function of a shock absorber (as a damper), with the ability to support sideways loads not along its axis of compression, somewhat similar to a sliding pillar suspension, thus eliminating the need for an upper suspension arm. This means that a strut must have a more rugged design, with mounting points ...
Another use of the swing axle concept is Ford's "Twin I-Beam" front suspension for trucks. This system has solid axles, and may transmit power in four-wheel-drive versions, where it is called "Twin Traction Beam". It is an independent suspension system, as each tyre rises and falls without affecting the position of the other.
The difference between them, however, is in the suspension and not the bearings. In a hard-bearing machine, balancing is done at a frequency lower than the resonance frequency of the suspension. Thus the suspension's resulting displacement is caused by the centrifugal force generated by the unbalance of the rotor.
Ad
related to: difference between suspension and spacer lift gate operator