Search results
Results from the WOW.Com Content Network
Ford — Dual-Stage Intake (DSI), on their Duratec 2.5 and 3.0-litre V6s, and it was also found on the Yamaha V6 in the Taurus SHO. The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control (IMRC) for four-valve engines, or the Charge Motion Control Valve (CMCV) for three-valve engines.
Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
The 4.8L and the 5.3L are smaller truck versions of the LS1 and were designed to replace the 305 and the 350 in trucks. The 4.8L and 5.3L engines share the same Gen III LS-series engine block and heads (upper end) and therefore, most parts interchange freely between these engines and other variants in the LS family.
Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.
Swirl flap principle in a four-valve engine. A swirl flap is a small butterfly valve fitted to four-stroke internal combustion engines with at least two intake valves.It is installed inside or just before one of a cylinder's two intake ports, allowing to throttle its intake port's air flow, causing a swirl in the other intake port not fitted with a swirl flap.
Intake assembly of a Ford Mustang showing pink air filter, plastic ducting with sensors, metal throttle body and plastic manifold with plenum and runners. Early automobile intake systems were simple air inlets connected directly to carburetors. The first air filter was implemented on the 1915 Packard Twin Six. [citation needed]
Fiat 875 cc two cylinder TwinAir engine featuring Multiair technology. MultiAir or Multiair is a hydraulically-actuated variable valve timing (VVT) and variable valve lift (VVL) engine technology enabling "cylinder by cylinder, stroke by stroke" [1] control of intake air directly via a gasoline engine's inlet valves.