Search results
Results from the WOW.Com Content Network
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
Albert Henry Lightburn (c. 1877 – 27 October 1940) was a son of Liverpool marine engineer John Bolton Lightburn (c. 1840 – 5 May 1916) and his wife Matilda Lightburn (13 May 1847 – 10 May 1930) who arrived in South Australia from England in 1898 and lived in Athelstone until after John's death, when she lived with Albert in Unley.
A radioisotope piezoelectric generator (RPG) is a type of radioisotope generator that converts energy stored in radioactive materials into motion, which is used to generate electricity using the repeated deformation of a piezoelectric material.
A load bank is a piece of electrical test equipment used to simulate an electrical load, to test an electric power source without connecting it to its normal operating load. [ 1 ] [ 2 ] During testing, adjustment, calibration, or verification procedures, a load bank is connected to the output of a power source, such as an electric generator ...
Industrial radiography is a modality of non-destructive testing that uses ionizing radiation to inspect materials and components with the objective of locating and quantifying defects and degradation in material properties that would lead to the failure of engineering structures. It plays an important role in the science and technology needed ...
Diagram of an RTG used on the Cassini probe. A radioisotope thermoelectric generator (RTG, RITEG), sometimes referred to as a radioisotope power system (RPS), is a type of nuclear battery that uses an array of thermocouples to convert the heat released by the decay of a suitable radioactive material into electricity by the Seebeck effect.
These may be used, for example, for factory and in-service testing of standby generators. A load bank may be used to stabilize a power system in case of loss of load, for example, on an isolated wind or mini-hydro plant. An electronic load (or e-load) is a device or assembly that simulates loading on an electronic circuit. It is used as ...
Typical lectromechanical Universal Testing Machine Test fixture for three point flex test. A universal testing machine (UTM), also known as a universal tester, [1] universal tensile machine, materials testing machine, materials test frame, is used to test the tensile strength (pulling) and compressive strength (pushing), flexural strength, bending, shear, hardness, and torsion testing ...