enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Brake fluid pressure sensor - Wikipedia

   en.wikipedia.org/wiki/Brake_fluid_pressure_sensor

   The sensor has an input port to measure the hydraulic braking pressure and an electrical connector output for a wire connection for feeding the warning light. Some brake failures do not trip the sensor into a fault mode. A brake fluid pressure sensor is used in anti-lock braking system (ABS). ABS fault lights come on with unexpected wheel lock ...

3. Brake fluid - Wikipedia

   en.wikipedia.org/wiki/Brake_fluid

   The brake fluid in the tubes, in turn, pressurizes the brake slave cylinders, which are on each wheel. [22] [23] The slave cylinder pistons press down the brake pads. They encompass and compress the brake disk, and the rotation of the wheels slows down. In addition to transmitting pressure, brake fluid also keeps the brake system working optimally.

4. Level sensor - Wikipedia

   en.wikipedia.org/wiki/Level_sensor

   Typical systems for point level detection in liquids include magnetic and mechanical floats, pressure sensors, electroconductive sensing or electrostatic (capacitance or inductance) detectors—and by measurement of a signal's time-of-flight to the fluid surface, through electromagnetic (such as magnetostrictive), ultrasonic, radar or optical ...

5. OBD-II PIDs - Wikipedia

   en.wikipedia.org/wiki/OBD-II_PIDs

   OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.

6. Brake tester - Wikipedia

   en.wikipedia.org/wiki/Brake_tester

   A roller brake tester is a method of allowing the dynamic assessment of the braking system of a motor vehicle, whilst the vehicle itself is in a static condition.This type of brake tester is normally used in UK garages when used as part of an inspection lane for the MOT test.

7. Anti-lock braking system - Wikipedia

   en.wikipedia.org/wiki/Anti-lock_braking_system

   Based on the input of the ECU, coils operate the inlet and outlet valves. During pressure release, the brake fluid is stored in accumulators. In this open system approach, the fluid is then brought back in the brake circuit via a pump operated by a motor that is felt through pulsation on the brake lever. [46]