enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are commonly color-coded to indicate the connector size and, hence, their capacity. They are commonly used as an alternative to terminal blocks or soldering of conductors, since they are quicker to install and, unlike soldered or crimped connections, allow easy subsequent removal for future modifications.

3. Board-to-board connector - Wikipedia

   en.wikipedia.org/wiki/Board-to-board_connector

   Board-to-board (BTB) connectors are used to connect printed circuit boards (PCB), electronic components that contain a conductive pattern printed on the surface of the insulating base in an accurate and repeatable manner. Each terminal on a BTB connector is connected to a PCB. A BTB connector includes housing and a specific number of terminals.

4. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Traditionally these connectors have been used with flat cable which makes it easy to ensure the correct conductors go into the correct slots. Modular connectors used with Category 5 twisted pair cable require careful arranging of the conductors by hand before inserting them into the connector.

5. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   FASTON terminals or faston terminals are connectors that are widely used in electronic and electrical equipment. These terminals are manufactured by many companies, commonly using the terms "quick disconnect", "quick connect", "tab" terminals, "spade" terminals [ 1 ] or blade connectors ; without qualifiers, the first two could be mistaken for ...

6. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   An electrical crimp is a type of solderless electrical connection which uses physical pressure to join the contacts. Crimp connectors are typically used to terminate stranded wire. [4] Stripped wire is inserted through the correctly sized opening of the connector, and a crimper is used to tightly squeeze the opening against the wire.

7. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   Generally, 6-series non-locking plugs are used for such appliances as large room air conditioners and commercial kitchen equipment; the occasional home arc welder also uses 6-50. [25] Single-phase 6-50 is commonly used on farms for silo unloaders, and is used with a 6-gauge flexible power cord up to 200 ft (61 m) long.

8. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Wires are typically attached to male or female blade connector terminals by either crimping or soldering. Insulated and uninsulated varieties are available. In some cases the blade is an integral manufactured part of a component (such as a switch or a speaker unit), and the reciprocal connector terminal is pushed onto the device's connector ...

9. Terminal (electronics) - Wikipedia

   en.wikipedia.org/wiki/Terminal_(electronics)

   Terminal symbol A terminal strip, to which wires can be soldered. A terminal is the point at which a conductor from a component, device or network comes to an end. [1] Terminal may also refer to an electrical connector at this endpoint, acting as the reusable interface to a conductor and creating a point where external circuits can be connected.