Search results
Results from the WOW.Com Content Network
This graph shows the pressure taken from the valve end (blue line) and the runner entrance(red line) of an engine with a 7-inch (180 mm) port/runner and running at 4500 rpm. Highlighted are two waves, a suction wave and a valve closing wave, seen and the valve end and runner entrance showing the signal delay.
The valve is next opened by moving it to the right, allowing the clear space in the middle of the valve to align with the channel in the cylinder above it. Piston valves are one form of valve used to control the flow of steam within a steam engine or locomotive .
Sleeve valve closeup from a Bristol Centaurus Mark 175. Bristol Perseus. The sleeve valve is a type of valve mechanism for piston engines, distinct from the usual poppet valve. Sleeve valve engines saw use in a number of pre–World War II luxury cars and in the United States in the Willys-Knight car and light truck. They subsequently fell from ...
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...
Carbon build-up in the intake manifold will occur when blow-by gases are allowed to permanently contaminate the intake air because of a failing PCV system. [12] Carbon build-up or oil sludge from blow-by gases on intake valves are usually not a problem in port injected engines. This is due to the fact that the fuel hits the intake valves on the ...
Gate valve, mainly for on–off control, with low pressure drop; Globe valve, good for regulating flow. Uses a cylinder movement over a seat; Knife valve, similar to a gate valve, but usually more compact. Often used for slurries or powders on–off control; Needle valve for accurate flow control; Pinch valve, for slurry flow regulation and ...
With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in drawing in the fresh charge. Engine designers ...
The hydraulic actuators respond to changes of pressure or flow and will open/close the valve. Automatic control valves do not require an external power source, meaning that the fluid pressure is enough to open and close them. Flow control valves, a type of automatic control valve, regulate fluid flow by maintaining a predetermined flow rate ...