Search results
Results from the WOW.Com Content Network
The term wet scrubber describes a variety of devices that remove pollutants from a furnace flue gas or from other gas streams. In a wet scrubber, the polluted gas stream is brought into contact with the scrubbing liquid, by spraying it with the liquid, by forcing it through a pool of liquid, or by some other contact method, so as to remove the pollutants.
Approximately 85% of the flue gas desulfurization units installed in the US are wet scrubbers, 12% are spray dry systems, and 3% are dry injection systems. The highest SO 2 removal efficiencies (greater than 90%) are achieved by wet scrubbers and the lowest (less than 80%) by dry scrubbers. However, the newer designs for dry scrubbers are ...
The exhaust gases of combustion may contain substances considered harmful to the environment, and the scrubber may remove or neutralize those. A wet scrubber is used for cleaning air, fuel gas or other gases of various pollutants and dust particles. Wet scrubbing works via the contact of target compounds or particulate matter with the scrubbing ...
A simple baffle scrubber system is shown in Figure 1. Liquid sprays capture pollutants and also remove collected particles from the baffles. Adding baffles slightly increases the pressure drop of the system. This type of technology is a part of the group of air pollution controls collectively referred to as wet scrubbers.
All venturi scrubbers require an entrainment separator because the high velocity of gas through the scrubber will have a tendency to entrain the droplets with the outlet clean gas stream. Cyclonic, mesh-pad, and blade separators are all used to remove liquid droplets from the flue gas and return the liquid to the scrubber water.
Figure 1-Centrifugal fan scrubber. Mechanically aided scrubbers are a form of pollution control technology. This type of technology is a part of the group of air pollution controls collectively referred to as wet scrubbers. In addition to using liquid sprays or the exhaust stream, scrubbing systems can use motors to supply energy.
A wet scrubber, or venturi scrubber, is similar to a cyclone but it has an orifice unit that sprays water into the vortex in the cyclone section, collecting all of the dust in a slurry system. The water media can be recirculated and reused to continue to filter the air. Eventually the solids must be removed from the water stream and disposed of.
Poisons, sulfur compounds, and fly ash can all be removed by installing scrubbers before the SCR system to increase the life of the catalyst, though in most power plants and marine engines, scrubbers are installed after the system to maximize the SCR system's effectiveness.