Search results
Results from the WOW.Com Content Network
A lean-to is originally defined as a structure in which the rafters lean against another building or wall, also referred to in prior times as a penthouse. [2] These structures characteristically have shed roofs, also referred to as "skillions", or "outshots" and "catslides" when the shed's roof is a direct extension of a larger structure's.
Pavilion roof : A low-pitched roof hipped equally on all sides and centered over a square or regular polygonal floor plan. [10] The sloping sides rise to a peak. For steep tower roof variants use Pyramid roof. Pyramid roof: A steep hip roof on a square building.
The building rests on a concrete-pier foundation and is covered by a log-frame side-gable roof surfaced with wood shingles. Pole purlins and rafters are exposed and the roof features a stone chimney extending from the gable ridge. A 2-step stoop of coursed, cut stone provides access to the vertical-plank door offset within the north elevation ...
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
Shed roof attached to a barn. A shed roof, also known variously as a pent roof, lean-to roof, outshot, catslide, skillion roof (in Australia and New Zealand), and, rarely, a mono-pitched roof, [1] is a single-pitched roof surface. This is in contrast to a dual- or multiple-pitched roof.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
For longer span rafters, building materials manufacturers have created laminated veneer lumber (LVL) rafters that can be 2–5 times longer than typical wood rafter. In the US, most wood rafters have maximum length of 20 feet (6.1 m). [5] If a longer rafter is needed, LVL is an alternative.