Search results
Results from the WOW.Com Content Network
In aircraft, a centrifugal switch is used to control the starting and ignition circuits, the governed speed indication circuit and the overspeed protection circuit of the auxiliary power unit. This switch is mounted inside a rotating body. This can be set to activate or deactivate a circuit as the rpm of device increases or decreases ...
The company began as a division of the Coleman Company in 1958 and was acquired by Evcon in 1990, which in turn was acquired by Johnson Controls in 1996. [70] [71] [72] Of the twelve largest American furnace brand names represented at Gas Furnace Guide, the Coleman brand received an average ranking of 3.7 out of 5 stars. [73]
If the switch is always open, the start capacitor is not part of the circuit, so the motor does not start. If the switch is always closed, the start capacitor is always in the circuit, so the motor windings will likely burn out. If a motor does not start, the capacitor is far more likely the problem than the switch. [citation needed]
An Automatic Oil Muffle Furnace, circa 1910. Petroleum is contained in tank A, and is kept under pressure by pumping at intervals with the wooden handle, so that when the valve B is opened, the oil is vaporized by passing through a heating coil at the furnace entrance, and when ignited burns fiercely as a gas flame.
A fault tree diagram. Fault tree analysis (FTA) is a type of failure analysis in which an undesired state of a system is examined. This analysis method is mainly used in safety engineering and reliability engineering to understand how systems can fail, to identify the best ways to reduce risk and to determine (or get a feeling for) event rates of a safety accident or a particular system level ...
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
Operating a vacuum heat treating furnace, c. 1959–1962. A vacuum furnace is a type of furnace in which the product in the furnace is surrounded by a vacuum during processing. The absence of air or other gases prevents oxidation, heat loss from the product through convection, and removes a source of contamination.
The SW9 was EMD's successor to the SW7.Like the SW7, the SW9 retained a power output of 1,200 hp and the same general design. It differed in lacking the upper hood vents found on the SW7, and with the installation of a 567B engine to replace the 567A found in the SW7.