enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Knipex - Wikipedia

   en.wikipedia.org/wiki/Knipex

   Knipex (English: / k ə ˈ n ɪ p ɛ k s /; [2] German pronunciation: [ˈknɪpɛks]) is a globally-distributed German manufacturer of hand tools, best known for its pliers.Knipex tools are principally used by professionals in various trades but find increasing popularity in DIY and EDC markets.

3. Diagonal pliers - Wikipedia

   en.wikipedia.org/wiki/Diagonal_pliers

   For electronics work, special diagonal cutters that are ground flush to the apex of the cutting edge on one side of the jaws are often used. These flush-cutting pliers allow wires to be trimmed flush or nearly flush to a solder joint, avoiding the sharp tip left by symmetrical diagonal cutters. It is common for this type of diagonal cutter to ...

4. Pliers - Wikipedia

   en.wikipedia.org/wiki/Pliers

   Diagonal pliers, also called side cutters, are a similarly shaped tool used for cutting rather than holding, having a pair of stout blades, similar to scissors except that the cutting surfaces meet parallel to each other rather than overlapping. Ordinary (holding/squeezing) pliers may incorporate a small pair of such cutting blades.

5. List of tool manufacturers - Wikipedia

   en.wikipedia.org/wiki/List_of_tool_manufacturers

   Cutting tools Snap-on: Wisconsin, US Snap-on, Bahco, Blue-Point, Williams, CDI Torque Products, [25] Sun diagnostic tools in Europe and Brazil: Hand tools, air tools, power tools, diagnostic tools, assorted automotive tools Sortimo: Zusmarshausen, Germany: Sortimo: in-vehicle equipment, storage system for parts and tools Stanley Black & Decker ...

6. Lineman's pliers - Wikipedia

   en.wikipedia.org/wiki/Lineman's_pliers

   Lineman's pliers (US English), Kleins (genericized trademark, US usage), linesman pliers (Canadian English), side cutting linesman pliers [1] and combination pliers (UK / US English) are a type of pliers used by lineworkers, electricians, and other tradesmen primarily for gripping, twisting, bending and cutting wire, cable, and small metalwork components.

7. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Side and end view of a Weldon style "zero flute" countersink. A cross-hole, "Weldon style" or "zero flute" countersink is a cone-shaped tool with a cutting edge provided by a hole that goes through the side of the cone. The intersection of the hole and cone form the cutting edge on the tool.