Search results
Results from the WOW.Com Content Network
The known hydrates and the approximate ranges of temperature and concentration (mass percent of NaOH) ... 10 20 30 40 50 Molar concentration of NaOH (M) 1.04 2.77 6. ...
In the International System of Units (SI), the coherent unit for molar concentration is mol/m 3. However, most chemical literature traditionally uses mol/dm 3, which is the same as mol/L. This traditional unit is often called a molar and denoted by the letter M, for example: 1 mol/m 3 = 10 −3 mol/dm 3 = 10 −3 mol/L = 10 −3 M = 1 mM = 1 ...
The molar conductivity of an electrolyte solution is defined as its conductivity divided by its molar concentration. [1][2] where: κ is the measured conductivity (formerly known as specific conductance), [3] c is the molar concentration of the electrolyte. The SI unit of molar conductivity is siemens metres squared per mole (S m 2 mol −1). [2]
m is known as the limiting molar conductivity, K is an empirical constant and c is the electrolyte concentration. (Limiting here means "at the limit of the infinite dilution".) In effect, the observed conductivity of a strong electrolyte becomes directly proportional to concentration, at sufficiently low concentrations i.e. when
The apparent molar volume of salt is usually less than the molar volume of the solid salt. For instance, solid NaCl has a volume of 27 cm 3 per mole, but the apparent molar volume at low concentrations is only 16.6 cc/mole. In fact, some aqueous electrolytes have negative apparent molar volumes: NaOH −6.7, LiOH −6.0, and Na 2 CO 3 −6.7 cm ...
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: feq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c (H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
Orders of magnitude (molar concentration) This page lists examples of the orders of magnitude of molar concentration. Source values are parenthesized where unit conversions were performed. M denotes the non-SI unit molar : 1 M = 1 mol/L = 10 −3 mol/m 3.
has a value close to 10 −14 at 25 °C, so the concentration of hydroxide ions in pure water is close to 10 −7 mol∙dm −3, to satisfy the equal charge constraint. The pH of a solution is equal to the decimal cologarithm of the hydrogen cation concentration; [ note 2 ] the pH of pure water is close to 7 at ambient temperatures.