Search results
Results from the WOW.Com Content Network
The oil collects in sump (1), is withdrawn continuously by scavenge pump (2) and travels to the oil tank (3), where gases entrained in the oil separate and the oil cools. Gases (6) are returned to the engine sump. Pressure pump (4) forces the de-gassed and cooled oil (5) back to the engine's lubrication points (7).
In an internal combustion engine, a head gasket provides the seal between the engine block and cylinder head(s). Its purpose is to seal the combustion gases within the cylinders and to avoid coolant or engine oil leaking into the cylinders. [1] Leaks in the head gasket can cause poor engine running and/or overheating.
Gear pumps [1] [2] trochoid pumps [3] and vane pumps [a] are all commonly used. Plunger pumps have been used in the past, but these are now only used rarely, for small engines . To avoid the need for priming , the pump is always mounted low-down, either submerged or around the level of the oil in the sump.
Dry sump engines in some drag racing cars use scavenging pumps to extract oil and gases from the crankcase. [18] A separator removes the oil, then the gases are fed into the exhaust system via a venturi tube. [citation needed]. This system maintains a small amount of vacuum in the crankcase and minimises the amount of oil in the engine that ...
Power – Sump pump motive power will vary from 1/4 horsepower to multiple horsepower. Head pressure – The hydraulic head pressure of a sump pump describes the maximum height to which the pump will move water. For instance, a sump pump with a 15 feet (4.6 m) maximum head (also called a shutoff head) will raise water up 15 feet (4.6 m) before ...
In most production automobiles and motorcycles, which use a wet sump system, the oil is collected in a 3 to 10 litres (0.66 to 2.20 imp gal; 0.79 to 2.64 US gal) capacity pan at the base of the engine, known as the sump or oil pan, where it is pumped back up to the bearings by the internal oil pump. A wet sump offers the advantage of a simple ...
Michigan Assembly Plant, formerly known as Michigan Truck Plant, is a Ford Motor Company assembly plant in Wayne, Michigan.The plant employs approximately 2,800 hourly employees and 200 salary employees (May 2020), [1] comprises three main buildings with 5,000,000 sq ft (460,000 m 2) of factory floor space and is located adjacent to Wayne Stamping & Assembly.
The Wayne Lifeguard is a type C school bus built by Wayne Corporation, introduced in 1973. Produced until Wayne Corporation declared bankruptcy and was liquidated in late 1992, the Lifeguard was also produced by successor Wayne Wheeled Vehicles until their closure in 1995. The Lifeguard introduced new methods of design and construction for ...