Search results
Results from the WOW.Com Content Network
GM S models have a longer tail-shaft than C/K trucks. Master & slave cylinder bore sizes went from standard to metric in 1992 (Master: 11/16"->18mm, Slave 13/16" ->20mm) GM and Dodge transmissions will not interchange. The case and bellhousing are one piece with differing, engine specific, bellhousing bolt patterns.
All Years have Dodge small block bellhousing to engine bolt pattern; 1992.5–2002 Used with 5.9 V8(5.2L v8 used NV3500) 2003–2005 5.7 hemi offered with 2500/3500 only; 1992.5 only 1" diameter 19 Spline input shaft; 1993–UP 1.125" diameter 10 Spline input shaft; 1992.5–UP 2WD 30 spline output; 1992.5–2000 4WD 23 spline output
A 2WD 5 speed transmission found in most light duty Toyota Dyna trucks, this transmission has a drum brake on the rear and steel housings. These transmissions can be used to give a significantly lower first, and a slightly higher overdrive (5th: 0.695:1) when fitted to an R151 4WD gearbox. [4] First Gear: 5.147:1; Second Gear: 2.74:1; Third ...
Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.
1.2/1.3/1.5/1.7L were mostly in European Cars. 1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard.
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
This model appears to have a combination of ratios used in older models of the W-series. 1st and 2nd are low ratios like in the W56 for use to get a heavy vehicle moving. 3rd ratio is the same as in the W57/W58 for a lower rpm drop between 3rd & 4th useful in high-speed acceleration. 4th is direct 1:1 as per design in these boxes.
The 5L40-E was designated in either "M82" (rear-wheel drive) or "MX5" (all-wheel drive) versions for service in BMW vehicles from 1999 model year until the design was superseded by (for BMW) the 6L45E and (for all others) the 6L50E series electronic automatic transmissions in 2007 . It is designed for service in vehicles up to 4000 lb (1814 kg ...