Search results
Results from the WOW.Com Content Network
Modern micrometer with a reading of 1.639 ± 0.005 mm. Assuming no zero error, this is also the measurement. (One may need to enlarge the image to read it.) Outside, inside, and depth micrometers. The outside micrometer has a unit conversion chart between fractional and decimal inch measurements etched onto the frame
Sensor, hypernym for devices that measure with little interaction, typically used in technical applications. Spectroscope is an important tool used by physicists. SWR meter check the quality of the match between the antenna and the transmission line .
In 1937 W.B. Schulte, [2] McGall's employer, started the company MICRO SWITCH. The company and the Micro Switch trademark have been owned by Honeywell Sensing and Control since 1950. [3] The name has become a generic trademark for any snap-action switch. Companies other than Honeywell now manufacture miniature snap-action switches.
A depth gauge is an instrument for measuring depth below a vertical reference surface. They include depth gauges for underwater diving and similar applications. A diving depth gauge is a pressure gauge that displays the equivalent depth below the free surface in water. The relationship between depth and pressure is linear and accurate enough ...
Simplified illustration of the process of fabrication of a CMOS inverter on p-type substrate in semiconductor microfabrication. Each etch step is detailed in the following image. The diagrams are not to scale, as in real devices, the gate, source, and drain contacts are not normally located in the same plane. Detail of an etch step.
The main difference between an Inertial measurement unit (IMU) and an AHRS is the addition of an on-board processing system in an AHRS, which provides attitude and heading information. This is in contrast to an IMU, which delivers sensor data to an additional device that computes attitude and heading.
Example applications for this type of sensor would be in the measuring of combustion pressure in an engine cylinder or in a gas turbine. These sensors are commonly manufactured out of piezoelectric materials such as quartz. Some pressure sensors are pressure switches, which turn on or off at a particular pressure. For example, a water pump can ...
Pneumatic level sensors are used where hazardous conditions exist, where there is no electric power or its use is restricted, or in applications involving heavy sludge or slurry. As the compression of a column of air against a diaphragm is used to actuate a switch, no process liquid contacts the sensor's moving parts. These sensors are suitable ...