Search results
Results from the WOW.Com Content Network
The ccTalk multidrop bus protocol uses an 8 bit TTL-level asynchronous serial protocol.It uses address randomization to allow multiple similar devices on the bus (after randomisation the devices can be distinguished by their serial number). ccTalk was developed by CoinControls, but is used by multiple vendors.
IO-Link is a short distance, bi-directional, digital, point-to-point, wired (or wireless), industrial communications networking standard (IEC 61131-9) used for connecting digital sensors and actuators to either a type of industrial fieldbus or a type of industrial Ethernet. [1]
The RapidIO architecture is a high-performance packet-switched electrical connection technology. It supports messaging, read/write and cache coherency semantics. Based on industry-standard electrical specifications such as those for Ethernet, RapidIO can be used as a chip-to-chip, board-to-board, and chassis-to-chassis interconnect.
FPM, EDO, SDR, and RDRAM memory was not commonly installed in a dual-channel configuration. DDR and DDR2 memory is usually installed in single- or dual-channel configuration. DDR3 memory is installed in single-, dual-, tri-, and quad-channel configurations. Bit rates of multi-channel configurations are the product of the module bit-rate (given ...
The first-generation IOIO boards (known as IOIO V1) contain the following on-board features: [34] [35] This generation only supports USB slave mode, and requires a USB master as the host (PC or newer Android phones). [2] [7] The IOIO V1 is a 3.3 V logic level device, and features a 5 V DC/DC switching regulator and a 3.3V linear regulator. [36]
Terabit Ethernet (TbE) is Ethernet with speeds above 100 Gigabit Ethernet. The 400 Gigabit Ethernet ( 400G , 400GbE ) and 200 Gigabit Ethernet ( 200G , 200GbE ) [ 1 ] standard developed by the IEEE P802.3bs Task Force using broadly similar technology to 100 Gigabit Ethernet [ 2 ] [ 3 ] was approved on December 6, 2017.
In the new chip generation, Intel therefore offered an optional port for a Gigabit Ethernet Controller directly attached to the MCH. The goal of this CSA technology was to reduce the latencies for Gigabit LAN by direct memory access and to free up bandwidth on the Hub interface between ICH and MCH for non removable disk and PCI data traffic.
The channel access control mechanism relies on a physical layer multiplex scheme. The most widespread multiple access method is the contention-based CSMA/CD used in Ethernet networks. This mechanism is only utilized within a network collision domain, for example, an Ethernet bus network or a hub-based star topology network.