enow.com Web Search

  1. Ad

    related to: uhf female impedance formula calculator chart pdf

Search results

  1. Results from the WOW.Com Content Network
  2. UHF connector - Wikipedia

    en.wikipedia.org/wiki/UHF_connector

    Virtually all of the impedance bump and consequent loss is in the UHF female connector, the SO-239. A typical SO-239 UHF female, properly hooded, has a difference in impedance from the standard 50 Ohm line impedance of about 35 Ohms. The length of the bump is typically ⁠ 1 / 2 ⁠ inch, where the female pin flares to fit over the male pin ...

  3. Stub (electronics) - Wikipedia

    en.wikipedia.org/wiki/Stub_(electronics)

    Stubs can match a load impedance to the transmission line characteristic impedance. The stub is positioned a distance from the load. This distance is chosen so that at that point, the resistive part of the load impedance is made equal to the resistive part of the characteristic impedance by impedance transformer action of the length of the main ...

  4. Characteristic impedance - Wikipedia

    en.wikipedia.org/wiki/Characteristic_impedance

    The input impedance of an infinite line is equal to the characteristic impedance since the transmitted wave is never reflected back from the end. Equivalently: The characteristic impedance of a line is that impedance which, when terminating an arbitrary length of line at its output, produces an input impedance of equal value. This is so because ...

  5. Impedance parameters - Wikipedia

    en.wikipedia.org/wiki/Impedance_parameters

    Z-parameters are also known as open-circuit impedance parameters as they are calculated under open circuit conditions. i.e., I x =0, where x=1,2 refer to input and output currents flowing through the ports (of a two-port network in this case) respectively.

  6. Free-space path loss - Wikipedia

    en.wikipedia.org/wiki/Free-space_path_loss

    In telecommunications, the free-space path loss (FSPL) (also known as free-space loss, FSL) is the attenuation of radio energy between the feedpoints of two antennas that results from the combination of the receiving antenna's capture area plus the obstacle-free, line-of-sight (LoS) path through free space (usually air). [1]

  7. List of RF connector types - Wikipedia

    en.wikipedia.org/wiki/List_of_RF_connector_types

    N connector "Type N" (Neill) 50 Ω or 75 Ω characteristic impedance connector (IEC 61169-16 [4]) NMD connector, standing for Network Measurements Division, are usually available as 3.5 mm, 2.9 mm, 2.4 mm, and 1.85 mm connectors. They are ruggedized test-port connectors used on test sets and network analyzers.

  8. Electrical characteristics of dynamic loudspeakers - Wikipedia

    en.wikipedia.org/wiki/Electrical_characteristics...

    The amplifier damping factor, which is the ratio of the nominal load impedance (driver voice coil) to amplifier output impedance, is adequate in either case for well-designed solid state amplifiers. Tube amplifiers have sufficiently higher output impedances that they normally included multi-tap output transformers to better match to the driver ...

  9. SWR meter - Wikipedia

    en.wikipedia.org/wiki/SWR_meter

    An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).

  1. Ad

    related to: uhf female impedance formula calculator chart pdf