enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. UHF connector - Wikipedia

    en.wikipedia.org/wiki/UHF_connector

    Virtually all of the impedance bump and consequent loss is in the UHF female connector, the SO-239. A typical SO-239 UHF female, properly hooded, has a difference in impedance from the standard 50 Ohm line impedance of about 35 Ohms. The length of the bump is typically ⁠ 1 / 2 ⁠ inch, where the female pin flares to fit over the male pin ...

  3. Stub (electronics) - Wikipedia

    en.wikipedia.org/wiki/Stub_(electronics)

    The free end of the stub is either left open-circuit, or short-circuited (as is always the case for waveguides). Neglecting transmission line losses, the input impedance of the stub is purely reactive ; either capacitive or inductive , depending on the electrical length of the stub, and on whether it is open or short circuit.

  4. Impedance of free space - Wikipedia

    en.wikipedia.org/wiki/Impedance_of_free_space

    The impedance of free space (that is, the wave impedance of a plane wave in free space) is equal to the product of the vacuum permeability μ 0 and the speed of light in vacuum c 0. Before 2019, the values of both these constants were taken to be exact (they were given in the definitions of the ampere and the metre respectively), and the value ...

  5. Free-space path loss - Wikipedia

    en.wikipedia.org/wiki/Free-space_path_loss

    In telecommunications, the free-space path loss (FSPL) (also known as free-space loss, FSL) is the attenuation of radio energy between the feedpoints of two antennas that results from the combination of the receiving antenna's capture area plus the obstacle-free, line-of-sight (LoS) path through free space (usually air). [1]

  6. Field strength meter - Wikipedia

    en.wikipedia.org/wiki/Field_strength_meter

    When measuring with a field strength meter it is important to use a calibrated antenna such as the standard antenna supplied with the meter. For precision measurements the antenna must be at a standard height. A value of standard height frequently employed for VHF and UHF measurements is 10 metres (33 ft).

  7. Impedance parameters - Wikipedia

    en.wikipedia.org/wiki/Impedance_parameters

    Z-parameters are also known as open-circuit impedance parameters as they are calculated under open circuit conditions. i.e., I x =0, where x=1,2 refer to input and output currents flowing through the ports (of a two-port network in this case) respectively.

  8. Waveguide (radio frequency) - Wikipedia

    en.wikipedia.org/wiki/Waveguide_(radio_frequency)

    In radio-frequency engineering and communications engineering, a waveguide is a hollow metal pipe used to carry radio waves. [1] This type of waveguide is used as a transmission line mostly at microwave frequencies, for such purposes as connecting microwave transmitters and receivers to their antennas, in equipment such as microwave ovens, radar sets, satellite communications, and microwave ...

  9. Horn antenna - Wikipedia

    en.wikipedia.org/wiki/Horn_antenna

    Pyramidal horn antennas for a variety of frequencies. They have flanges at the top to attach to standard waveguides. A horn antenna is used to transmit radio waves from a waveguide (a metal pipe used to carry radio waves) out into space, or collect radio waves into a waveguide for reception.