enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Patch cable - Wikipedia

   en.wikipedia.org/wiki/Patch_cable

   A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.

3. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

4. Fiber-optic patch cord - Wikipedia

   en.wikipedia.org/wiki/Fiber-optic_patch_cord

   The inner diameter measures 9 μm for single-mode cables, and 50 / 62.5 μm for multi-mode cables. The development of "reduced bend radius" fiber in the mid-2000s, enabled a trend towards smaller cables. Each unit of diameter reduction in a round cable, produces a disproportionate corresponding reduction in the space the cable occupies. [1]

5. Networking cable - Wikipedia

   en.wikipedia.org/wiki/Networking_cable

   A patch cable is an electrical or optical cable used to connect one electronic or optical device to another for signal routing. Devices of different types (e.g. a switch connected to a computer, or a switch connected to a router) are connected with patch cables.

6. Optical fiber connector - Wikipedia

   en.wikipedia.org/wiki/Optical_fiber_connector

   Pre-terminated cable assemblies; outdoor applications [15] MT-RJ: Mechanical Transfer Registered Jack or Media Termination - recommended jack [9] Latch, gendered [1] — 2.45×4.4 mm IEC 61754-18 Duplex multimode connections [E] MU Miniature unit [9] Latch, push-pull — 1.25 mm IEC 61754-6 Common in Japan [1] SC: Subscriber connector, [9 ...

7. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...