Search results
Results from the WOW.Com Content Network
Additionally, for Wrangler owners with high-horsepower GM LS engines, the 14-bolt can handle the engines' increased stress. [8] Many Wrangler owners will have up to two inches removed from the bottom of the 10.5" 14-bolt differential housing to maximize ground clearance. [9] The popularity of GM trucks and vans made 10.5" 14-bolt axles a common ...
In 1999, AAM went public, and is traded as "AXL" on the New York Stock Exchange (NYSE). AAM has grown to supply various OEM manufacturers around the globe in the passenger car, light truck, and commercial vehicle segments. AAM's World Headquarters building, erected in 2004, is located on the Detroit/Hamtramck border.
Rear-axle shafts are 30 spline. The rear 11.5" has a gear ratio "carrier split" at 3.73 and numerically higher, but the General Motors AAM axles used a different carrier spacing preventing the installation of a Chrysler carrier into some GM axles, but the GM carrier can be installed in the Chrysler axle if a ring gear spacer is installed.
The axles are manufactured by American Axle & Manufacturing, Inc. The front is an AAM 9.25 and the rear is a hybrid AAM 10.5 with the larger axle shafts from the AAM 11.5. Despite the fact the axles have locking differentials, the rear axle is also a helical-type limited-slip differential when unlocked. The Power Wagon is equipped with a 4.56:1 ...
At least till 2011 the 12 bolt semi float was still found with the heavy duty f-150. Gear ratios were 3.73 in 4x4 and either the 3.73 or 4.10 in the two-wheel-drive models. This was available in both limited slip and standard variations. All 4x4 came with limited slip (L on tag), it can also be determined from the axle code on the door jamb vin ...
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard. The Mitsubishi transmission was made to fit Mustang IIs and was shoehorned into the early Rangers.
The bolt pattern is 5x112 (12 mm x 1.5 lugs), with an offset range of 30–40 mm, a wheel size range of 16"x6.0" to 20"x8.5". This is the same bolt pattern as most Mercedes, including the previous E-Class (W124).