Search results
Results from the WOW.Com Content Network
A routing table is a data file in RAM that is used to store route information about directly connected and remote networks. Nodes can also share the contents of their routing table with other nodes. The primary function of a router is to forward a packet toward its destination network, which is the destination IP address of the packet.
Cisco Discovery Protocol (CDP) is a proprietary data link layer protocol developed by Cisco Systems in 1994 [1] by Keith McCloghrie and Dino Farinacci. It is used to share information about other directly connected Cisco equipment, such as the operating system version and IP address.
Routing calculates good paths through a network for information to take. For example, from node 1 to node 6 the best routes are likely to be 1-8-7-6, 1-8-10-6 or 1-9-10-6, as these are the shortest routes. Routing is the process of selecting network paths to carry network traffic. Routing is performed for many kinds of networks, including ...
Administrative distance (AD) or route preference [1] is a number of arbitrary unit assigned to dynamic routes, static routes and directly-connected routes. The value is used in routers to rank routes from most preferred (low AD value) to least preferred (high AD value).
More recently, this hierarchical technique was applied to wireless mesh networks using the Optimized Link State Routing Protocol (OLSR). Where a connection can have varying quality, the quality of a connection can be used to select better connections. This is used in some ad hoc routing protocols that use radio frequency transmission. [citation ...
Multiprotocol Label Switching (MPLS) is a routing technique in telecommunications networks that directs data from one node to the next based on labels rather than network addresses. [1] Whereas network addresses identify endpoints , the labels identify established paths between endpoints.
Router2 manages its attached networks and default gateway; router 3 does the same; router 1 manages all routes within the internal networks. Accessing internal resources If PC2 (172.16.1.100) needs to access PC3 (192.168.1.100), since PC2 has no route to 192.168.1.100 it will send packets for PC3 to its default gateway (router2).
Depending on the implementation of that process, the BGP route is not necessarily selected. For example, a directly connected prefix, learned from the router's own hardware, is usually most preferred. As long as that directly connected route's interface is active, the BGP route to the destination will not be put into the routing table.