Search results
Results from the WOW.Com Content Network
These pipelines can be disconnected and reconnected too. 10 liters of water for cooling are used with a pump, producing a flow of approximately 30 liters per minute. [5] A sensor system has also been installed into the Aquasar system to further monitor the performance.
Direct digital control is the automated control of a condition or process by a digital device (computer). [ 1 ] [ 2 ] Direct digital control takes a centralized network-oriented approach. All instrumentation is gathered by various analog and digital converters which use the network to transport these signals to the central controller.
Many systems used in telecommunications use an extra-low voltage "common battery" 48 V DC power, because it has less restrictive safety regulations, such as being installed in conduit and junction boxes. DC has typically been the dominant power source for telecommunications, and AC has typically been the dominant source for computers and servers.
12V only System monitoring (P10): This is a 171822-8 AMP or equivalent connector carrying a supply to the PSU fan and sense returns. [32] ATX12V 4-pin power connector (also called the P4 power connector). A second connector that goes to the motherboard (in addition to the 24-pin ATX motherboard connector) to supply dedicated power for the ...
A 0.75 HP bore-well submersible pump which had been used to pump groundwater One style of submersible pump for industrial use. Outlet pipe and electrical cable not connected. A submersible pump (or electric submersible pump (ESP) is a device which has a hermetically sealed motor close-coupled to the pump body. The whole assembly is submerged in ...
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...
A minimum flow protection system ensures that the pump is not operated below the minimum flow rate. The system protects the pump even if it is shut-in or dead-headed, that is, if the discharge line is completely closed. [44] The simplest minimum flow system is a pipe running from the pump discharge line back to the suction line.
In a battery electric vehicle, there are usually two separate DC systems. The "low voltage" DC system typically operates at 12V, and serves the same purpose as in an internal combustion engine vehicle. [10] The "high voltage" system operates at 300-400V (depending on the vehicle), and provides the power for the traction motors. [11]