Ads
related to: dc 12v water pump for computer system parts and functions test
Search results
Results from the WOW.Com Content Network
These pipelines can be disconnected and reconnected too. 10 liters of water for cooling are used with a pump, producing a flow of approximately 30 liters per minute. [5] A sensor system has also been installed into the Aquasar system to further monitor the performance.
The principle used in a typical (active) liquid cooling system for computers is identical to that used in an automobile's internal combustion engine, with the water being circulated by a water pump through a water block mounted on the CPU (and sometimes additional components as GPU and northbridge) [24] and out to a heat exchanger, typically a ...
The system power consumption is a sum of the power ratings for all of the components of the computer system that draw on the power supply. Some graphics cards (especially multiple cards) and large groups of hard drives can place very heavy demands on the 12 V lines of the PSU, and for these loads, the PSU's 12 V rating is crucial.
A regulated power supply is an embedded circuit; it converts unregulated AC (alternating current) into a constant DC. With the help of a rectifier it converts AC supply into DC. Its function is to supply a stable voltage (or less often current), to a circuit or device that must be operated within certain power supply limits.
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...
In a battery electric vehicle, there are usually two separate DC systems. The "low voltage" DC system typically operates at 12V, and serves the same purpose as in an internal combustion engine vehicle. [10] The "high voltage" system operates at 300-400V (depending on the vehicle), and provides the power for the traction motors. [11]
A voltage regulator is a system designed to automatically maintain a constant voltage. It may use a simple feed-forward design or may include negative feedback. It may use an electromechanical mechanism, or electronic components. Depending on the design, it may be used to regulate one or more AC or DC voltages.
A minimum flow protection system ensures that the pump is not operated below the minimum flow rate. The system protects the pump even if it is shut-in or dead-headed, that is, if the discharge line is completely closed. [44] The simplest minimum flow system is a pipe running from the pump discharge line back to the suction line.
Ads
related to: dc 12v water pump for computer system parts and functions test