Search results
Results from the WOW.Com Content Network
Packet loss occurs when one or more packets of data travelling across a computer network fail to reach their destination. Packet loss is either caused by errors in data transmission, typically across wireless networks, [1] [2] or network congestion. [3]: 36 Packet loss is measured as a percentage of packets lost with respect to packets sent.
This used to be the most common method of pre-deployment Wi-Fi survey. During an active survey, the wireless adapter is associated with one or several access points to measure round-trip time, throughput rates, packet loss, and retransmissions. Active surveys are used to troubleshoot Wi-Fi networks or to verify performance post-deployment.
Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...
Network congestion in data networking and queueing theory is the reduced quality of service that occurs when a network node or link is carrying more data than it can handle. . Typical effects include queueing delay, packet loss or the blocking of new connectio
iperf, Iperf, or iPerf, is a tool for network performance measurement and tuning. It is a cross-platform tool that can produce standardized performance measurements for any network. iperf has client and server functionality, and can create data streams to measure the throughput between the two ends in one or both directions. [2]
In TCP/IP, routers operate within the Internet layer, while the transmission rate is handled by the endpoints at the transport layer. Congestion may be handled only by the transmitter, but since it is known to have happened only after a packet was sent, there must be an echo of the congestion indication by the receiver to the transmitter.
When packet loss occurs in the network, an additional limit is imposed on the connection. [2] In the case of light to moderate packet loss when the TCP rate is limited by the congestion avoidance algorithm , the limit can be calculated according to the formula (Mathis, et al.):
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).