Search results
Results from the WOW.Com Content Network
Traditional Swedish units of measurement were standardized by law in 1665, prior to which they only existed as a number of related but differing local variants. The system was slightly revised in 1735. In 1855, a decimal reform was instituted that defined a new Swedish inch as 1⁄10 Swedish foot (2.96 cm or 1.17 inches).
The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to translate similar units in other measurement systems, usually understood as ...
Table of length units. 1⁄12 of a ligne. This unit is usually called the Truchet point in English. Prior to the French Revolution the Fournier point was also in use. It was 1⁄6 of a ligne or 1⁄864 of the smaller French foot. 1⁄12 of a pouce. This corresponds to the line, a traditional English unit. 1⁄12 of a pied du roi.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
The United States dollar is fully decimal, being divided into 10 dimes, 100 cents (¢), and (for accounting purposes) 1000 mills (₥); [72] this mirrors the decimal divisions of metric units with the prefixes deci-, centi-, and milli-. Coins are currently minted in 1, 5, 10, 25, 50, and 100-cent increments. [73]
A thousandth of an inch is a derived unit of length in a system of units using inches. Equal to 1000 of an inch, a thousandth is commonly called a thou / ˈθaʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils). The words are shortened forms of the English and Latin words for "thousand" (mille in Latin).