Search results
Results from the WOW.Com Content Network
An oil burner is a part attached to an oil furnace, water heater, or boiler. [1] It provides the ignition of heating oil/biodiesel fuel used to heat either air or water via a heat exchanger . The fuel is atomized into a fine spray usually by forcing it under pressure through a nozzle which gives the resulting flame a specific flow rate, angle ...
When compression reaches a point that the fresh fuel reaches the red-hot area of the tube, ignition occurs. On early designs, ignition timing was adjusted by adjusting the position of the red-hot spot on the tube - the burner is moved towards the far end to retard ignition, and towards the base to advance.
Pre-ignition and engine knock both sharply increase combustion chamber temperatures. Consequently, either effect increases the likelihood of the other effect occurring, and both can produce similar effects from the operator's perspective, such as rough engine operation or loss of performance due to operational intervention by a powertrain ...
Now it is more common to light a burner electrically, but gas pilot lights are still used when a high energy ignition source is necessary, as in when lighting a large burner. A United States patent was filed May 13, 1922, for a "safety gas-control system" by two employees of the Newark, New Jersey–based Public Service Gas Company, Conrad ...
The burner in the vertical, cylindrical furnace as above, is located in the floor and fires upward. Some furnaces have side fired burners, such as in train locomotives. The burner tile is made of high temperature refractory and is where the flame is contained. Air registers located below the burner and at the outlet of the air blower are ...
A piezo igniter element from a typical lighter. Piezo ignition is a type of ignition that is used in portable camping stoves, gas grills and some lighters. [1] Piezo ignition uses the principle of piezoelectricity, which is the electric charge that accumulates in some materials in response to mechanical deformation.
The crankshaft rests in these bearings, with either one or two flywheels and a clutch fastened to it. A great number of oil field engines used a crosshead to connect the piston rod to the connecting rod; this slides back and forth between the bedplate and crosshead guides. Ignition in the combustion chamber is either by hot tube or spark plug.
An Argand lamp used whale oil, seal oil, colza, olive oil [2] or other vegetable oil as fuel which was supplied by a gravity feed from a reservoir mounted above the burner. A disadvantage of the original Argand arrangement was that the oil reservoir needed to be above the level of the burner because the heavy, sticky vegetable oil would not ...