Ads
related to: 4 0 copper cable cutter
Search results
Results from the WOW.Com Content Network
Diagonal pliers (also known as wire cutters or diagonal cutting pliers, or under many regional names) are pliers intended for the cutting of wire or small stock, rather than grabbing or turning. The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a diagonal", giving pliers their name.
Lineman's pliers (US English), Kleins (genericized trademark, US usage), linesman pliers (Canadian English), side cutting linesman pliers [1] and combination pliers (UK / US English) are a type of pliers used by lineworkers, electricians, and other tradesmen primarily for gripping, twisting, bending and cutting wire, cable, and small metalwork components.
This device allows even a novice to strip most wires very quickly. The compound automatic wire stripper's cutter must be short, because it causes the jaws to twist, as described by Wood in the 1943 patent. All wire strippers are inherently limited to those wire sizes the cutting jaw notches will accommodate.
[3] [4] Bristol staged a series of 52 tests of the WSPS by mounting it on the fuselage of a wrecked Kiowa; the fuselage was loaded onto a flatbed truck and driven into wires at speeds ranging from 15 to 60 mph (13 to 52 kn; 24 to 97 km/h), yaw angles ranging from 0 to 45°, and a variety of cables that were typically used in overhead power and ...
The largest machines can handle stock up to 3 in (76 mm) wide, 12.5 in (320 mm) long, and 3 ⁄ 32 in (2.4 mm) thick. For wires the limit is 1 ⁄ 8 in (3.175 mm). [3] Other limits are the travel on the slides, which maxes out at 3 ⁄ 4 in (19.05 mm), and the throw of the forming cams, which is between 7 ⁄ 8 and 2 in (22
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The upper and lower diamond guides are usually accurate to 0.004 mm (0.16 mils), and can have a cutting path or kerf as small as 0.021 mm (0.83 mils) using Ø 0.02 mm (0.79 mils) wire, though the average cutting kerf that achieves the best economic cost and machining time is 0.335 mm (13.2 mils) using Ø 0.25 mm (9.8 mils) brass wire.
A wire catcher consists of a strip of angle iron bolted upright to the forward bumper of a jeep. [1] [2] [3] "It extends above the heads of those riding in the jeep, and is notched a few inches from the top so that any wire extending across the road will be caught and snipped."
Ads
related to: 4 0 copper cable cutter