Search results
Results from the WOW.Com Content Network
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
The combination of the panhard rod and the torque tube allows the easy implementation of soft coil springs in the rear to give good ride quality, as in Buicks after 1937. Before 1937, Buicks used leaf springs, so the panhard rod was not used, though the torque tube allowed a cantilever spring suspension, which gives a softer ride than a center ...
The Mercedes-Benz CLK GTR (chassis code C297) [5] is a GT1 sports car built and produced by Mercedes-Benz in conjunction with their then motorsport partner AMG.Intended for racing in the new FIA GT Championship series in 1997, the CLK GTR was designed primarily as a race car.
A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever, the torsion key, mounted perpendicular to the bar, that is attached to a ...
Suspension is the system of tires, tire air, springs, shock absorbers and linkages that connects a vehicle to its wheels and allows relative motion between the two. [1] Suspension systems must support both road holding/handling and ride quality, [2] which are at odds with each other. The tuning of suspensions involves finding the right compromise.
A Panhard rod (also called Panhard bar, track bar, or track rod) is a suspension link that provides lateral location of the axle. [1] Originally invented by the Panhard automobile company of France in the early twentieth century, this device has been widely used ever since.
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
The opposite arrangement, a "pull rod", will pull on the rod during bump travel, and the rod must be attached to the top of the upright, angled downward. Locating the spring and damper inboard increases the total mass of the suspension, but reduces the unsprung mass, and also allows the designer to make the suspension more aerodynamic.