enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

3. Clip-on nut - Wikipedia

   en.wikipedia.org/wiki/Clip-on_nut

   An M6 spire clip or chimney U-nut for a bolt and a #8 u-nut for a self-tapping screw. A U-nut is very similar to a J-nut except that both legs are the same length. Because of this a retaining clip is usually formed on the leg without the threads. This helps keep the nut in place while not screwed down.

4. Distorted thread locknut - Wikipedia

   en.wikipedia.org/wiki/Distorted_thread_locknut

   A distorted thread locknut, [1] is a type of locknut that uses a deformed section of thread to keep the nut from loosening due to vibrations, or rotation of the clamped item. . There are four types: elliptical offset nuts, centerlock nuts, toplock nuts and partially depitched (Philidas) nu

5. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A machine screw or bolt is usually a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.), usually intended to screw into a pre-formed thread, either a nut or a threaded (tapped) hole, unlike a wood or self-tapping screw. Machine ...

6. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 2 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...

7. Wall plug - Wikipedia

   en.wikipedia.org/wiki/Wall_plug

   A wall plug (UK English) also known as an anchor (US) or "Rawlplug" (UK), is a fibre or plastic (originally wood) insert used to enable the attachment of a screw in a material that is porous or brittle, or that would otherwise not support the weight of the object attached with the screw. [1] [2] It is a type of anchor that can be used to allow ...