Search results
Results from the WOW.Com Content Network
Off-roading tires may use a different measurement scheme: Tread width × Outside diameter, followed by wheel size (all in inches) – for example 31×10.50R15 (787 mm × 267 mm R380 in metric designation). The size of the wheel, however, is denoted as 8.5 in × 20.0 in (220 mm × 510 mm).
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
7.02 mm: Model railways (0) Exact O scale of 7 mm = 1 foot. 1:43: 7.088 mm: Die-cast cars: Still the most popular scale for die-cast cars worldwide, metric or otherwise. It originates from British O scale. 1:40: 0.3 in: 7.620 mm The very early models of the British Coronation Coach and a few other horse-drawn wagons were made in this scale.
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Competitive pressures induced most North American railways to convert to standard gauge by 1880, but Southern railroads retained their distinct, 5 ft (1,524 mm) gauge. In 1884 and 1885, two important railroads connecting Chicago to the South, the Illinois Central and the Mobile and Ohio Railroad , converted to standard gauge, increasing ...
ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if feet and inches are ...
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...