Search results
Results from the WOW.Com Content Network
An H-bridge is an electronic circuit that switches the polarity of a voltage applied to a load. These circuits are often used in robotics and other applications to allow DC motors to run forwards or backwards. [ 1 ]
In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.
VIA chipsets support CPUs from Intel, AMD (e.g. the Athlon 64) and VIA themselves (e.g. the VIA C3 or C7).They support CPUs as old as the i386 in the early 1990s. In the early 2000s, their chipsets began to offer on-chip graphics support from VIA's joint venture with S3 Graphics beginning in 2001; this support continued into the early 2010s, with the release of the VX11H in August 2012.
A stepper motor A bipolar hybrid stepper motor. Brushed DC motors rotate continuously when DC voltage is applied to their terminals. The stepper motor is known for its property of converting a train of input pulses (typically square waves) into a precisely defined increment in the shaft’s rotational position.
Half-Bridge can refer to: A single-direction configuration of an H-Bridge motor controller; A form of DC to DC converter switched-mode power supply. One of a pair of devices that connect to perform the Bridging (networking) function of a computer network
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A device does not conform to the Wishbone specification unless it includes a data sheet that describes what it does, bus width, utilization, etc. Promoting reuse of a design requires the data sheet. Making a design reusable in turn makes it easier to share with others.
It is sometimes, thus, referred to as free and open-source hardware (FOSH), meaning that the design is easily available ("open") and that it can be used, modified and shared freely ("free"). [ citation needed ] The term usually means that information about the hardware is easily discerned so that others can make it – coupling it closely to ...