enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Dual ball joint suspension - Wikipedia

   en.wikipedia.org/wiki/Dual_ball_joint_suspension

   The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...

3. Ball joint - Wikipedia

   en.wikipedia.org/wiki/Ball_joint

   A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...

4. Toyota Electronic Modulated Suspension - Wikipedia

   en.wikipedia.org/wiki/Toyota_Electronic...

   TEMS consisted of four shock absorbers mounted at all four wheels, and could be used in either an automatic or driver selected mode based on the installation of the system used. The technology was installed on top-level Toyota products with four wheel independent suspension, labeled PEGASUS (Precision Engineered Geometrically Advanced SUSpension).

5. Car suspension - Wikipedia

   en.wikipedia.org/wiki/Car_suspension

   The torque tube surrounded the true driveshaft and exerted the force to its ball joint at the extreme rear of the transmission, which was attached to the engine. A similar method like this was used in the late 1930s by Buick and by Hudson 's bathtub car in 1948, which used helical springs that could not take fore-and-aft thrust.

6. Dana 60 - Wikipedia

   en.wikipedia.org/wiki/Dana_60

   The 2nd Generation axles were driver's side with ball joints. 30 spline axle shafts were used instead of 35 splines, except 2000, 2001 and 2002 models which were equipped with 32 spline axle shafts. GM versions are passenger side differential drop, standard rotation gears, kingpin knuckles and 35 spline axle shafts.

7. Ball-and-socket joint - Wikipedia

   en.wikipedia.org/wiki/Ball-and-socket_joint

   The ball-and-socket joint (or spheroid joint) is a type of synovial joint in which the ball-shaped surface of one rounded bone fits into the cup-like depression of another bone. The distal bone is capable of motion around an indefinite number of axes, which have one common center. This enables the joint to move in many directions.