Search results
Results from the WOW.Com Content Network
BIOS POST card for ISA bus BIOS POST card for PCI bus Professional BIOS POST card for PCI bus Two POST seven-segment displays integrated on a computer motherboard. The original IBM BIOS made POST diagnostic information available by outputting a number to I/O port 0x80 (a screen display was not possible with some failure modes). Both progress ...
File verification is the process of using an algorithm for verifying the integrity of a computer file, usually by checksum. This can be done by comparing two files bit-by-bit, but requires two copies of the same file, and may miss systematic corruptions which might occur to both files.
Intel Trusted Execution Technology (Intel TXT, formerly known as LaGrande Technology) is a computer hardware technology of which the primary goals are: Attestation of the authenticity of a platform and its operating system. Assuring that an authentic operating system starts in a trusted environment, which can then be considered trusted.
File integrity monitoring (FIM) is an internal control or process that performs the act of validating the integrity of operating system and application software files using a verification method between the current file state and a known, good baseline.
Nonvolatile BIOS memory refers to a small memory on PC motherboards that is used to store BIOS settings. It is traditionally called CMOS RAM because it uses a volatile, low-power complementary metal–oxide–semiconductor (CMOS) SRAM (such as the Motorola MC146818 [1] or similar) powered by a small battery when system and standby power is off. [2]
In computing, serial presence detect (SPD) is a standardized way to automatically access information about a memory module.Earlier 72-pin SIMMs included five pins that provided five bits of parallel presence detect (PPD) data, but the 168-pin DIMM standard changed to a serial presence detect to encode more information.
The BIOS in some computers, when matched with operating systems such as some versions of Linux, BSD, and Windows (Windows 2000 and later [13]), allows counting of detected and corrected memory errors, in part to help identify failing memory modules before the problem becomes catastrophic.
A second checksum is used for the upcase table. This is a static table and should never change. Any corruption in the table could prevent files from being located because this table is used to convert the filenames to upper case when searching to locate a file. The third checksum is in the directory file sets.