Search results
Results from the WOW.Com Content Network
Argon is used in some high-temperature industrial processes where ordinarily non-reactive substances become reactive. For example, an argon atmosphere is used in graphite electric furnaces to prevent the graphite from burning. For some of these processes, the presence of nitrogen or oxygen gases might cause defects within the material.
The inertness of noble gases makes them useful whenever chemical reactions are unwanted. For example, argon is used as a shielding gas in welding and as a filler gas in incandescent light bulbs. Helium is used to provide buoyancy in blimps and balloons. Helium and neon are also used as refrigerants due to their low boiling points.
A gas regulator attached to a nitrogen cylinder. Industrial gases are the gaseous materials that are manufactured for use in industry.The principal gases provided are nitrogen, oxygen, carbon dioxide, argon, hydrogen, helium and acetylene, although many other gases and mixtures are also available in gas cylinders.
The flue gas system uses the boiler exhaust as its source, so it is important that the fuel/air ratio in the boiler burners is properly regulated to ensure that high-quality inert gases are produced. Too much air would result in an oxygen content exceeding 5%, and too much fuel oil would result in the carryover of dangerous hydrocarbon gas.
The standards below are two examples of commonly used and cited publications that provide a composition for standard dry air: ISO TR 29922-2017 provides a definition for standard dry air which specifies an air molar mass of 28,965 46 ± 0,000 17 kg·kmol-1. [2] GPA 2145:2009 is published by the Gas Processors Association.
Solid argon-hydrogen clathrate (Ar(H 2) 2) has the same crystal structure as the MgZn 2 Laves phase. It forms at pressures between 4.3 and 220 GPa, though Raman measurements suggest that the H 2 molecules in Ar(H 2) 2 dissociate above 175 GPa. A similar Kr(H 2) 4 solid forms at pressures above 5 GPa. It has a face-centered cubic structure where ...
A-25 (25% argon/75% helium) is used for nonferrous base when higher heat input and good weld appearance are needed. A-50 (50% argon/50% helium) is used for nonferrous metals thinner than 0.75 inch for high-speed mechanized welding. A-75 (75% argon/25% helium) is used for mechanized welding of thick aluminium. Reduces weld porosity in copper. [14]
A nitrogen generator Bottle of 4Å molecular sieves. Pressure swing adsorption provides separation of oxygen or nitrogen from air without liquefaction. The process operates around ambient temperature; a zeolite (molecular sponge) is exposed to high pressure air, then the air is released and an adsorbed film of the desired gas is released.