Search results
Results from the WOW.Com Content Network
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
Recently some users have implemented the simplex repeater system, a cheap and easy way to extend the radio range by using extra radios connected to a small repeater controller. This is also known as "Parrot", "ATX-2000" or just "Echo Repeater" after how it sounds repeating every transmission it receives. [22] PMR446 gateways extend the range of ...
Repeater equipment: GMSK Node Adapter - these devices are hardware GMSK modems with firmware to take D-STAR protocol frames over a USB cable and provide the necessary logic and GMSK modulation to control a simplex node or a full duplex repeater. One repeater that is easily adaptable is the Kenwood TKR-820 as documented by K7VE. [27]
Repeaters are the lifeline of the ham radio operator. They are the towers that relay messages between ham radios, accepting the weak incoming signal and then transmitting it at a higher power, so ...
The method is frequently used in ham radio operation, where an operator is attempting to use a repeater station. The repeater station must be able to send and receive a transmission at the same time and does so by slightly altering the frequency at which it sends and receives. This mode of operation is referred to as duplex mode or offset mode.
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [ 1 ]
It is a protocol, implemented in a computer program, used for weak-signal radio communication between amateur radio operators. The protocol was designed, and a program written initially, by Joe Taylor, K1JT. The software code is now open source and is developed by a small team.
To avoid interference within the equipment at the station, the two frequencies used need to be separated, and ideally on different 'bands'. An unattended station working in this way is a radio repeater. It re-transmits the same information that it receives. This principle is used by telecommunications satellites and terrestrial mobile radio ...