Search results
Results from the WOW.Com Content Network
When characteristic impedance is , and one wants to split power as and , and ≠ , then the design can be created following the equations: A new constant K {\displaystyle K} is defined for ease of expression, where K 2 = P 3 P 2 {\displaystyle K^{2}={\frac {P_{3}}{P_{2}}}}
The respective tables of data were generally developed by using the more complex transfer function method to determine the various cooling loads for different types of heating. [ 2 ] [ 3 ] The results gained by doing so are then normalized for each type of heat gain used for the tables, CLTD, CLF, and SCL.
The length of a sinusoidal wave is commonly expressed as an angle, in units of degrees (with 360° in a wavelength) or radians (with 2π radians in a wavelength). So alternately the electrical length can be expressed as an angle which is the phase shift of the wave between the ends of the conductor [1] [3] [5]
Having the same units on both sides of an equation does not ensure that the equation is correct, but having different units on the two sides (when expressed in terms of base units) of an equation implies that the equation is wrong. For example, check the universal gas law equation of PV = nRT, when: the pressure P is in pascals (Pa)
The formulas for addition and subtraction involving a small angle may be used for interpolating between trigonometric table values: Example: sin(0.755) = (+) + () + () where the values for sin(0.75) and cos(0.75) are obtained from trigonometric table. The result is accurate to the four digits given.
The effective temperature coefficient varies with temperature and purity level of the material. The 20 °C value is only an approximation when used at other temperatures. For example, the coefficient becomes lower at higher temperatures for copper, and the value 0.00427 is commonly specified at 0 °C. [53]
Figure 1: Schematic of an electrical circuit illustrating current division. Notation R T refers to the total resistance of the circuit to the right of resistor R X.. In electronics, a current divider is a simple linear circuit that produces an output current (I X) that is a fraction of its input current (I T).
The plate distance is one centimeter, the special conductivity values were calculated from the Lasance approximation formula in The Thermal conductivity of Air at Reduced Pressures and Length Scales [28] and the primary values were taken from Weast at the normal pressure tables in the CRC handbook on page E2. [27]