enow.com Web Search

  1. Ads

    related to: edelbrock rpm intake manifold

Search results

  1. Results from the WOW.Com Content Network
  2. Edelbrock - Wikipedia

    en.wikipedia.org/wiki/Edelbrock

    Vic Edelbrock founded the corporation in 1938 when his desire to increase the performance of his 1932 Ford Roadster led him to design a new intake manifold, [3] friends and fellow drivers soon wanted one as well. This transformed his repair garage into a parts manufacturing enterprise, making one-of-a-kind equipment for automobiles.

  3. Mitsubishi 6B3 engine - Wikipedia

    en.wikipedia.org/wiki/Mitsubishi_6B3_engine

    Over 3,600 rpm, the flap opens, providing a shorter tract to the valves to increase power. Positioning the EGR distribution inlet on the upper intake manifold, far from the throttle valve, improves real-world fuel consumption by lowering the temperature entering the EGR distribution passageway. [1]

  4. Vic Edelbrock - Wikipedia

    en.wikipedia.org/wiki/Vic_Edelbrock

    Otis Victor Edelbrock, Sr. (August 16, 1913 – November 11, 1962) [1] was an American automotive aftermarket performance parts engineer, racer and is considered one of the founders of the American hot rod movement [2] Victor, known as "Vic", established Edelbrock Corporation in Beverly Hills in 1938 and is the father to Otis Victor Edelbrock, Jr., who was from 1962 to 2010 president and was ...

  5. Multi-valve - Wikipedia

    en.wikipedia.org/wiki/Multi-valve

    A cylinder head of a four valve Nissan VQ engine engine. A multi-valve or multivalve engine is one where each cylinder has more than two valves (an intake, and an exhaust).A multi-valve engine has better breathing, and with more smaller valves (having less mass in motion) may be able to operate at higher revolutions per minute (RPM) than a two-valve engine, delivering more power.

  6. Chevrolet Turbo-Thrift engine - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_Turbo-Thrift_engine

    Starting in 1979, a two-barrel intake fitted with a Rochester Varajet carburetor and dual take down exhaust manifold were used in trucks and vans. The "integrated" cylinder head and intake manifold claimed to have resulted in increased low end torque and fuel economy inclusive of a smoother operation, lowering NVH ( noise, vibration, and ...

  7. Mercedes-Benz M272 engine - Wikipedia

    en.wikipedia.org/wiki/Mercedes-Benz_M272_engine

    This was achieved by raising the rev-limit to 7200 rpm, increasing the compression ratio using enhanced, weight-optimized pistons with a curved surface, reinforcements in the area of the piston pins, deeper pockets for the valve seats, single-stage intake manifold, lightweight valves with sodium cooling, conical valve springs, tri-oval chain ...

  1. Ads

    related to: edelbrock rpm intake manifold